|
Scaling In Gmax |
|
This is an explanation of my method of scaling a project in Gmax. I had tried the method of using the X-form modifier and found if this was done after designing a model for the earlier version of makemdl that it made a lot of work that was repetitious. This way seems to eliminate having to do any re-animantions and very little re-mapping of textures. This tutorial will take you from importing a DXF file to setting up and positioning for export to FS2k2. |
|
Setup
|
| To set-up for METERS, click on Customize, then Preferences. |
|
|
| Under the GENERAL tab you will find the System Unit Scale settings. |
 |
| Next you will want to setup the units you prefer to work with. My choice is Decimal Feet. |
| This is handy as it allow you to take measurements from the project and use them in the aircraft.cfg file. |
 |
| Next: Importing a DXF file. |